[news:entitle] -杏耀注册

[news:entitle]

approach:

1) will move the knife tip up

2) remove the knife-edge dirty, need to clean

3) remove the knife does not match the core od, please replace the corresponding removal of the blade

4) laser mouth and move the knife edge position is not aligned, move away.

5) wire is not laser open

6) the tail is too short to be completely removed

7) removal knife edge is not flat

8) removal knife edge above or below the line fixture platform

9) when the small steel plate is loaded into the fixture, the wire is reversed

10) small steel plate after the binder and the knife is too high or too small

11) knife mouth dirty

12) diversion size is too long

13) removal of the blade and the wire is not on the same line